Gravure Cylinder Cleaner
The Gravure Cylinder Cleaner 2300 ATEX is made for cleaning of gravure cylinders with solvents. It is safe to use and gentle on the cylinders, meaning that you can clean the cylinders as often as needed. Consistent and high quality print is only achieved if the cylinders are completely clean.
The system is based on solvents sprayed on the cylinder. The system is effective for all types of rotogravure cylinders. The cleaning process leaves the cylinders totally clean and ready for immediate reuse or storage. The cylinders are cleaned without causing any wear or tear.
The Gravure Cylinder Cleaner 2300 Atex can be equipped with end face brushes, which can clean the end face of the cylinder. The brushes are slowly oscillating to remove the ink.
The Cleaning Process
The quick and gentle cleaning process leaves the cylinders totally clean and ready for immediate use after up to 45 minutes cleaning without causing any wear or tear to the aniloxes.
The cleaning cycle consists of the following steps:
3. Rinsing (this is an option on the Gravure Cylinder Cleaner)
The Gravure Cylinder Cleaner will help you reduce manpower by cleaning the gravure cylinders in an efficient way. Consistent and high quality print is only achieved if the cylinders are completely clean.
- Fully automatic, gentle and quick washing process.
- Time saving and user friendly.
- Stainless steel.
- Minimal Maintenance
|GCC 2300||GCC 2300-2|
|Max. total cylinder length (incl. shaft)||2300 mm||2300 mm|
|Max. face length||1400 mm||1400 mm|
|Max. repeat length||1130 mm||1130 mm|
|Min. repeat length (other on demand)||360 mm||360 mm|
|Max. cylinder weigth||200 kg||2 x 200 kg|